Cisco SPS2024 - Global Configuration Mode

Introduction
CLI Command Modes
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 20
1
Console#
Console# disable
Console>
Global Configuration Mode
The Global Configuration mode is used to configure features at the system level,
and not at the interface level.
To access Global Configuration mode from Privileged EXEC mode, enter the
configure command at the Privileged EXEC mode prompt and press Enter. The
Global Configuration mode prompt, consisting of the device host name followed
by (config)#, is displayed:
Console(config)#
Use any of the following commands to return from Global Configuration mode to
the Privileged EXEC mode:
exit
end
Ctrl+Z
The following example shows how to access Global Configuration mode and
return to Privileged EXEC mode:
Console#
Console# configure
Console(config)# exit
Console#