Cisco SPS2024 - Police Aggregate

QoS Commands
police aggregate
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 284
23
Example
The following example displays the parameters of the aggregate policer called
‘policer1’.
Console# show qos aggregate-policer policer1
aggregate-policer policer1 96000 4800 exceed-action drop
not used by any policy map
police aggregate
The police aggregate Policy-map Class Configuration mode command applies an
aggregate policer to multiple classes within the same policy map. Use the no form
of this command to remove an existing aggregate policer from a policy map.
Syntax
police aggregate aggregate-policer-name
no police aggregate aggregate-policer-name
Parameters
•
aggregate-policer-name — Specifies the name of the aggregate policer.
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
An aggregate policer can be applied to multiple classes in the same policy map;
An aggregate policer cannot be applied across multiple policy maps or interfaces.