Ethernet Configuration Commands
port storm-control include-multicast
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 177
12
User Guidelines
Use the port storm-control broadcast enable Interface Configuration mode
command to enable Broadcast storm control.
Example
The following example configures a port storm-control Broadcast rate of 4000 on
port e2.
Console(config)# interface ethernet e2
Console(config-if)# port storm-control broadcast rate 4000
port storm-control include-multicast
The port storm-control include-multicast Interface Configuration mode command
enables counting Multicast packets in the port storm-control broadcast rate
command. Use the no form of this command to disable counting Multicast packets.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
Default Configuration
Multicast packets are disabled.
Command Mode
Interface Configuration mode
User Guidelines
To control Multicasts storms, use the port storm-control broadcast enable and port
storm-control broadcast rate commands.
To Next Page
Loading...
