Cisco SPS2024 - Qos Cos

QoS Commands
qos cos
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 300
23
Default Configuration
qos trust is enabled on each port when the system is in basic mode.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port e15 to the default trust state.
Console(config)# interface ethernet e15
Console(config-if) qos trust
qos cos
The qos cos Interface Configuration (Ethernet, port-channel) mode command
defines the default CoS value of a port. Use the no form of this command to restore
the default configuration.
Syntax
qos cos default-cos
no qos cos
Parameters
•
default-cos — Specifies the default CoS value of the port. (Range: 0-7)