Ethernet Configuration Commands
speed
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 154
12
speed
The speed Interface Configuration (Ethernet, port-channel) mode command
configures the speed of a given Ethernet interface when not using auto-
negotiation.
NOTE To configure the speed of a fiber SFP port, use the sfp speed command.
Syntax
speed {10 | 100 | 1000| 10000}
Parameters
•
10 — Forces 10 Mbps operation.
• 100 — Forces 100 Mbps operation.
• 1000 — Forces 1000 Mbps operation.
• 10000 — Forces 10000 Mbps operation.
Default Configuration
Maximum port capability: 38400
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
