Cisco SPS2024 - Qos Map Dscp-Queue

QoS Commands
qos map dscp-queue
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 296
23
qos map dscp-queue
The qos map dscp-queue Global Configuration mode command modifies the
DSCP to CoS map. Use the no form of this command to restore the default map.
Syntax
qos map dscp-queue dscp-list to queue-id
no qos map dscp-queue
Parameters
•
dscp-list — Specifies up to 8 DSCP values separated by a space. (Range: 0
- 63)
• queue-id — Specifies the queue number to which the DSCP values are
mapped.
Default Configuration
The following table describes the default map.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
DSCP
Value
0-7 8-15 16-23 24-31 32-39 40-47 48-56 57-63
Queue-ID12345678