Cisco SPS2024 - Ip Domain-Name

IP Address Commands
ip domain-name
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 219
15
ip domain-name
The ip domain-name Global Configuration mode command defines a default
domain name used by the software to complete unqualified host names (names
without a dotted-decimal domain name). Use the no form of this command to
remove the default domain name.
Syntax
ip domain-name name
no ip domain-name
Parameters
•
name — Specifies the default domain name used to complete unqualified
host names. Do not include the initial period that separates an unqualified
name from the domain name. (Range: 1-158 characters)
Default Configuration
A default domain name is not defined.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example defines default domain name www.LinkSys.com.
Console(config)# ip domain-name www.LinkSys.com