Cisco SPS2024 - Port Storm-Control Broadcast Rate

Ethernet Configuration Commands
port storm-control broadcast rate
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 176
12
Use the port storm-control include-multicast Global Configuration mode
command to enable counting Multicast packets in the storm control calculation.
Example
The following example enables Broadcast storm control on port 1 of a device.
Console(config)# interface ethernet 1
Console(config-if)# port storm-control broadcast enable
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode
command configures the maximum Broadcast rate. Use the no form of this
command to restore the default configuration.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
•
rate — Maximum kilobits per second of Broadcast and Multicast traffic on a
port. (Range for GE ports: 3500 K–100 M,
range for FE ports: 70 K – 100 M, range for SPS2024 devices: 3.5 M - 1 G)
Default Configuration
The default storm control broadcast rate for FE ports is 100 Kbits/Sec and for GE
ports is 500 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode