Cisco SPS2024 - Chapter 12: Ethernet Configuration Commands; Interface Ethernet

12
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 150
Ethernet Configuration Commands
interface ethernet
The interface ethernet Global Configuration mode command enters the interface
configuration mode to configure an Ethernet type interface.
Syntax
interface ethernet interface
Parameters
•
interface — Valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables configuring Ethernet port e18.
Console(config)# interface ethernet e18