Cisco SPS2024 - Show Interfaces Access-Lists

ACL Commands
show interfaces access-lists
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 62
3
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays access lists defined on a device.
Console# show access-lists
IP access list ACL1
permit ip host 172.30.40.1 any
permit rsvp host 172.30.8.8 any
show interfaces access-lists
The show interfaces access-lists Privileged EXEC mode command displays
access lists applied on interfaces.
Syntax
show interfaces access-lists [ethernet interface | port-channel port-channel-
number]
Parameters
•
interface — Valid Ethernet port.
• port-channel-number — Valid port-channel number.