Cisco SPS2024 - Set Interface Active

Ethernet Configuration Commands
set interface active
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 165
12
Example
In the following example, the counters for interface 1 are cleared.
Console# clear counters ethernet e1
set interface active
The set interface active Privileged EXEC mode command reactivates a shutdown
interface.
Syntax
set interface active {ethernet interface | port-channel port-channel-number }
Parameters
•
interface — Valid Ethernet port.
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command is used to activate interfaces that were configured to be active, but
were shutdown by the system for some reason (e.g., port security).