Cisco SPS2024 - Show Lacp Ethernet

LACP Commands
show lacp ethernet
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 238
17
Example
The following example assigns a long administrative LACP timeout to Ethernet
port e6.
Console(config)# interface ethernet e6
Console(config-if)# lacp timeout long
show lacp ethernet
The show lacp ethernet Privileged EXEC mode command displays LACP
information for Ethernet ports.
Syntax
show lacp ethernet interface [parameters | statistics | protocol-state]
Parameters
•
interface — Valid Ethernet port.
• parameters — Link aggregation parameter information.
• statistics — Link aggregation statistics information.
• protocol-state — Link aggregation protocol-state information.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.