Management ACL Commands
permit (management)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 249
19
Parameters
•
name—
Specifies the Access List name. (Range: 1-32 characters)
• console-only—Indicates that the device can be managed only from the
console.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures an access list called ‘mlist’ as the management
access list.
Console(config)# management access-class mlist
permit (management)
The permit Management Access-List Configuration mode command defines a
permit rule.
Syntax
permit ip-source
ip-address
[mask
mask
|
prefix-length
]
To Next Page
Loading...
