Management ACL Commands
permit (management)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 250
19
Parameters
•
ip-address
— A valid source IP address.
•
mask
— A valid network mask of the source IP address.
•
prefix-length
— Number of bits that comprise the source IP address prefix.
The prefix length must be preceded by a forward slash (/). (Range: 0-32)
•
vlan
— The VLAN number.
•
port-channel
— The port-channel number.
•
service
— The service type condition.
Default Configuration
If no permit rule is defined, the default is set to deny.
Command Mode
Management Access-list Configuration mode.
User Guidelines
The system supports up to 128 management access rules.
Example
The following example permits all ports in the access list called ‘mlist’.
Console(config)# management access-list mlist
Console(config-macl)# permit ip-source 172.16.15.3 ethernet e3
To Next Page
Loading...
