Clock Commands
sntp server
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 116
6
sntp server
The sntp server Global Configuration mode command configures the device to
use the Simple Network Time Protocol (SNTP) to request and accept SNTP traffic
from a specified server. Use the no form of this command to remove a server from
the list of SNTP servers.
Syntax
sntp server {
ip-address
|
hostname
} [oll] [key
keyid
]
no sntp server host
Parameters
•
ip-address —
IP address of the server.
•
hostname
— Hostname of the server. (Range: 1-158 characters; Maximum
label size: 63)
• poll — Enable polling.
•
keyid
— Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the sntp unicast client enable Global Configuration mode command to enable
predefined Unicast clients globally.
To Next Page
Loading...
