Cisco SPS2024 - Chapter 19: Management ACL Commands; Management Access-List

19
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 247
Management ACL Commands
management access-list
The management access-list Global Configuration mode command configures a
management Access List and enters the Management Access-List Configuration
command mode. Use the no form of this command to delete an Access List.
Syntax
management access-list name
no management access-list name
Parameters
•
name— Specifies the Access List name. (Range: 1-32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Use this command to configure a management Access List. This command
converts the device to Access-List Configuration mode, where the denied or
permitted access conditions with the deny and permit commands must be
defined.