802.1x Commands
dot1x max-req
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 524
36
Default Configuration
Timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following command sets the number of seconds that the device waits for a
response to an EAP-request/identity frame, to 3600 seconds.
Console(config)# interface ethernet e16
Console(config-if)# dot1x timeout tx-period 3600
dot1x max-req
The dot1x max-req Interface Configuration mode command sets the maximum
number of times that the device sends an Extensible Authentication Protocol
(EAP)-request/identity frame (assuming that no response is received) to the client,
before restarting the authentication process. Use the no form of this command to
restore the default configuration.
Syntax
dot1x max-req
count
no dot1x max-req
To Next Page
Loading...
