Cisco SPS2024 - Bridge Aging Time

Address Table Commands
bridge aging time
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 83
5
Example
In this example, forwarding all Multicast packets to e1 with VLAN 2 is forbidden.
Console(config)# interface vlan 2
Console(config-if)# bridge multicast forbidden forward-all add
ethernet e1
bridge aging time
The bridge aging-time Global Configuration mode command sets the address
table aging time. To restore the default configuration, use the no form of this
command.
Syntax
bridge aging-time seconds
no bridge aging-time
Parameters
•
seconds — Time in seconds. (Range: 10-630 seconds)
Default Configuration
The default setting is 300 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.