Cisco SPS2024 - Chapter 16: IP Source Guard Commands; Ip Source-Guard (Global)

16
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 226
IP Source Guard Commands
ip source-guard (global)
The ip source-guard Global Configuration mode command globally enables the IP
source guard. Use the no form of this command to disable IP source guard.
Syntax
ip source-guard
no ip source-guard
Default Configuration
IP source guard is disabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables the IP source guard.
Console(config)# ip source-guard