Cisco SPS2024 - Chapter 17: LACP Commands; Lacp System-Priority

17
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 235
LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the
system priority. Use the no form of this command to restore the default
configuration.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
•
value — Specifies system priority value. (Range: 1-65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.