Cisco SPS2024 - Snmp-Server Enable Traps

SNMP Commands
snmp-server enable traps
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 348
26
snmp-server enable traps
The snmp-server enable traps Global Configuration mode command enables the
device to send SNMP traps. Use the no form of this command to disable SNMP
traps.
Syntax
snmp-server enable traps
no snmp-server enable traps
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables SNMP traps.
Console(config)# snmp-server enable traps