ACL Commands
service-policy
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 60
3
service-policy
Apply a policy map to the input of a particular interface. Use no form in order to
detach policy map from interface.
The command is available in Advanced mode only.
Syntax
service-policy input policy-map-name
no service-policy input
Parameters
•
input — Use input policy-map-name to apply the specified policy-map to
the input interface.
• policy-map-name — Up to 32 characters.
Default Configuration
This command has no default configuration.
Command Mode
Interface configuration (Ethernet, VLAN, Port-Channel)
User Guidelines
Only one policy map per interface per direction is supported.
service-acl
To control access to an interface, use the service-acl command in interface
configuration mode. To remove the access control, use the no form of this
command.
To Next Page
Loading...
