IGMP Snooping Commands
ip igmp snooping mrouter
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 194
14
ip igmp snooping mrouter
The ip igmp snooping mrouter Interface Configuration (VLAN) mode command
enables automatic learning of Multicast device ports in the context of a specific
VLAN. Use the no form of this command to remove automatic learning of Multicast
device ports.
Syntax
ip igmp snooping mrouter learn-pim-dvmrp
no ip igmp snooping mrouter learn-pim-dvmrp
Default Configuration
Automatic learning of Multicast device ports is enabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Multicast device ports can be configured statically using the bridge multicast
forward-all Interface Configuration (VLAN) mode command.
Example
The following example enables automatic learning of Multicast device ports on
VLAN 2.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping mrouter learn-pim-dvmrp
To Next Page
Loading...
