Management ACL Commands
deny (management)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 251
19
deny (management)
The deny Management Access-List Configuration mode command defines a deny
rule.
Syntax
deny ip-source
ip-address
[mask
mask
|
prefix-length
]
Parameters
•
ip-address
— A valid source IP address.
•
mask
— A valid network mask of the source IP address.
•
prefix-length
— Specifies the number of bits that comprise the source IP
address prefix. The prefix length must be preceded by a forward slash (/).
(Range: 0-32)
•
vlan
— The VLAN number.
•
port-channel
— The port-channel number.
•
service
— The service type condition.
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
The system supports up to 128 management access rules.
To Next Page
Loading...
