IGMP Snooping Commands
ip igmp snooping multicast-tv
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 199
14
Example
The following example configures the host leave timeout to 60 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping leave-time-out 60
ip igmp snooping multicast-tv
The ip igmp snooping multicast-tv Global Configuration mode command defines
the Multicast ip-addresses that are associated with a Multicast-TV VLAN. Use the
no form of this command to remove all associations.
Syntax
ip igmp snooping multicast-tv vlan
vlan-id
{add | remove}
ip-multicast-address
[count
number
]
no ip igmp snooping multicast-tv vlan
vlan-id
Parameters
•
vlan-id —
Specifies the VLAN ID of the Multicast-TV VLAN.
•
ip-multicast-address
— Specifies an IP address to associate with the
Multicast-TV VLAN.
•
number
— Configures multiple contiguous Multicast IP addresses. If
unspecified, the default is 1. (Range: 1-256)
Default Configuration
The default configuration has no Multicast IP address associated with it.
Command Mode
Global Configuration mode
To Next Page
Loading...
