System Management Commands
show system
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 452
31
The following table describes significant fields shown above.
show system
The show system Privileged EXEC mode command displays system information.
Syntax
show system [unit
unit
]
Parameters
•
unit
— Specifies the number of the unit. (Range: 1-8)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
Field Description
Connection Connection number
Host Remote host to which the device is connected
through a Telnet session.
Address IP address of the remote host.
Port Telnet TCP port number
Byte Number of unread bytes for the user to see on the
connection.
To Next Page
Loading...
