Cisco SPS2024 - Tacacs-Server Timeout

TACACS+ Commands
tacacs-server timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 459
32
tacacs-server timeout
The tacacs-server timeout Global Configuration mode command sets the interval
during which the device waits for a TACACS+ server to reply. Use the no form of
the command to restore the default configuration.
Syntax
tacacs-server timeout timeout
no tacacs-server timeout
Parameters
•
timeout — Specifies the timeout value in seconds. (Range: 1-30)
Default Configuration
5 seconds
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the timeout value to 30 for all TACACS+ servers.
Console(config)# tacacs-server timeout 30