Cisco SPS2024 - Show Ports Security

Address Table Commands
show ports security
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 96
5
Example
In this example, the Multicast configuration for VLAN 1 is displayed.
Console# show bridge multicast filtering 1
Filtering: Enabled
VLAN: 1
Port Static Status
---- --------- ---------
e1 Filter
e2 Filter
e3 Filter
show ports security
The show ports security Privileged EXEC mode command displays the port-lock
status.
Syntax
show ports security [ethernet interface | port-channel port-channel-number ]
Parameters
•
interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode