Cisco SPS2024 - Exit(Exec)

User Interface Commands
exit(EXEC)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 465
33
Default Configuration
This command has no default configuration.
Command Mode
All configuration modes
User Guidelines
There are no user guidelines for this command.
Example
The following example changes the configuration mode from Interface
Configuration mode to Privileged EXEC mode.
Console(config-if)# exit
Console(config)# exit
Console#
exit(EXEC)
The exit Privileged/User EXEC mode command closes an active terminal session
by logging off the device.
Syntax
exit
Default Configuration
This command has no default configuration.
Command Mode
Privileged and User EXEC modes