Cisco SPS2024 - Ip Ssh Pubkey-Auth

SSH Commands
ip ssh pubkey-auth
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 405
29
ip ssh pubkey-auth
The ip ssh pubkey-auth Global Configuration mode command enables public key
authentication for incoming SSH sessions. Use the no form of this command to
disable this function.
Syntax
ip ssh pubkey-auth
no ip ssh pubkey-auth
Default Configuration
Public Key authentication to incoming SSH sessions is disabled.
Command Mode
Global Configuration mode
User Guidelines
AAA authentication is independent.
Example
The following example enables public key authentication for incoming SSH
sessions.
Console(config)# ip ssh pubkey-auth