QoS Commands
qos wrr-queue threshold
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 294
23
no qos wrr-queue threshold tengigabitethernet
queue-id
Parameters
•
gigabitethernet — Indicates that the thresholds are to be applied to Gigabit
Ethernet ports.
• tengigabitethernet — Indicates that the thresholds are to be applied to 10
Gigabit Ethernet ports.
•
queue-id
— Specifies the queue number to which the threshold is assigned.
•
threshold-percentage0,1,2 —
Specifies the queue threshold percentage
value. Each value is separated by a space. (Range: 0-100)
Default Configuration
80 percent for all thresholds.
Command Mode
Global Configuration mode.
User Guidelines
The packet refers to a certain threshold by the conformance level. If threshold 0 is
exceeded, packets with the corresponding DP are dropped until the threshold is
no longer exceeded. However, packets assigned to threshold 1 or 2 continue to be
queued and sent as long as the second or third threshold is not exceeded.
Example
The following example assigns a threshold of 80 percent to WRR queue 1.
Console (config)# qos wrr-queue threshold gigabitethernet 1 80
To Next Page
Loading...
