SNMP Commands
snmp-server user
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 340
26
• auth-md5
password —
Indicates the HMAC-MD5-96 authentication level.
The user should enter a password for authentication and generation of a
DES key for privacy. (Range: 1-32 characters)
• auth-sha
password —
Indicates the HMAC-SHA-96 authentication level.
The user should enter a password for authentication and generation of a
DES key for privacy. (Range: 1-32 characters)
• auth-md5-key
md5-des-keys —
Indicates the HMAC-MD5-96
authentication level. The user should enter a concatenated hexadecimal
string of the MD5 key (MSB) and the privacy key (LSB). If authentication is
only required, 16 bytes should be entered; if authentication and privacy are
required, 32 bytes should be entered. Each byte in the hexadecimal
character string is two hexadecimal digits. Each byte can be separated by a
period or colon. (16 or 32 bytes)
• auth-sha-key
sha-des-keys
— Indicates the HMAC-SHA-96 authentication
level. The user should enter a concatenated hexadecimal string of the SHA
key (MSB) and the privacy key (LSB). If authentication is only required, 20
bytes should be entered; if authentication and privacy are required, 36
bytes should be entered. Each byte in the hexadecimal character string is
two hexadecimal digits. Each byte can be separated by a period or colon.
(20 or 36 bytes)
Default Configuration
No group entry exists.
Command Mode
Global Configuration mode
User Guidelines
If auth-md5 or auth-sha is specified, both authentication and privacy are enabled
for the user.
When a show running-config Privileged EXEC mode command is entered, a line for
this user will not be displayed. To see if this user has been added to the
configuration, type the show snmp users Privileged EXEC mode command.
To Next Page
Loading...
