Cisco SPS2024 - Page 345

SNMP Commands
snmp-server host
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 343
26
Parameters
•
ip-address — Specifies the IP address of the host (targeted recipient).
• hostname — Specifies the name of the host. (Range:1-158 characters)
• community-string — Specifies a password-like community string sent with
the notification operation. (Range: 1-20)
• traps — Indicates that SNMP traps are sent to this host. If unspecified,
SNMPv2 traps are sent to the host.
• informs — Indicates that SNMP informs are sent to this host. Not applicable
to SNMPv1.
• 1 — Indicates that SNMPv1 traps will be used.
• 2 — Indicates that SNMPv2 traps will be used. If
• port— Specifies the UDP port of the host to use. If unspecified, the default
UDP port number is 162. (Range:1-65535)
• filtername — Specifies a string that defines the filter for this host. If
unspecified, nothing is filtered. (Range: 1-30 characters)
• seconds — Specifies the number of seconds to wait for an
acknowledgment before resending informs. If unspecified, the default
timeout period is 15 seconds. (Range: 1-300)
• retries — Specifies the maximum number of times to resend an inform
request. If unspecified, the default maximum number of retries is 3. (Range:
0-255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode