SNMP Commands
show snmp groups
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 357
26
Parameters
•
groupname—
Specifies the name of the group. (Range: 1-30)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of views.
Console# show snmp groups
Name Security Views
Model Level Read Write Notify
------------- ----- ----- ---- ----- ------
user-group V3 priv Default ““
managers-group V3 priv Default ““
managers-group V3 priv Default ““ ““
The following table describes significant fields shown above.
Field Description
Name Name of the group.
Security Mode SNMP model in use (v1, v2 or v3).
Security Level Authentication of a packet with encryption.
Applicable only to SNMP v3 security.
To Next Page
Loading...
