AAA Commands
enable authentication
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 38
2
Syntax
enable authentication {default |
list-name
}
no enable authentication
Parameters
•
default — Uses the default list created with the aaa authentication enable
command.
•
list-name
— Uses the indicated list created with the aaa authentication
enable command.
Default Configuration
Uses the default set with the aaa authentication enable command.
Command Mode
Line Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies the default authentication method when
accessing a higher privilege level from a console.
Console(config)# line console
Console(config-line)# enable authentication default
To Next Page
Loading...
