TACACS+ Commands
tacacs-server host
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 457
32
•
source
— Specifies the source IP address to use for the communication.
0.0.0.0 indicates a request to use the IP address of the outgoing IP interface.
•
priority
— Determines the order in which the TACACS+ servers are used,
where 0 is the highest priority. (Range: 0-65535)
Default Configuration
No TACACS+ host is specified.
If no port number is specified, default port number 49 is used.
If no host-specific timeout, key-string or source value is specified, the global value
is used.
If no TACACS+ server priority is specified, default priority 0 is used.
Command Mode
Global Configuration mode
User Guidelines
Multiple tacacs-server host commands can be used to specify multiple hosts.
Example
The following example specifies a TACACS+ host.
Console(config)# tacacs-server host 172.16.1.1
To Next Page
Loading...
