Cisco SPS2024 - Page 528

802.1x Commands
dot1x timeout supp-timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 526
36
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response to an EAP-
request frame from the client before resending the request. (Range: 1-
65535 seconds)
Default Configuration
Default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the timeout period before retransmitting an EAP-
request frame to the client to 3600 seconds.
Console(config)# interface ethernet e16
Console(config-if)# dot1x timeout supp-timeout 3600