ACL Commands
deny (IP)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 53
3
Syntax
deny [disable-port] {any |
protocol
} {any | {
source source-wildcard
}} {ny |
{
destination destination-wildcard
}} [dscp
dscp number
| ip-precedence
ip-
precedence
]
deny-icmp [disable-port] {any | {
source source-wildcard
}} {any | {
destination
destination-wildcard
}} {ny |
icmp-type
} {any |
icmp-code
} [dscp
number
| ip-
precedence
number
]
deny-igmp [disable-port] {any | {
source source-wildcard
}} {any | {
destination
destination-wildcard
}} {any |
igmp-type
} [dscp
number
| ip-precedence
number
]
deny-tcp [disable-port] {any | {
source source-wildcard
}} {any |
source-port
} {any |
{
destination destination-wildcard
}} {any |
destination-port
} [dscp
number
| ip-
precedence
number
] [flags
list-of-flags
]
eny-udp [disable-port] {any | {
source source-wildcard
}} {any |
source-port
} {any |
{
destination destination-wildcard
}} {any |
destination-port
} [dscp
number
| ip-
precedence
number
]
Parameters
•
disable-port — Specifies that the port is disabled.
•
source
— Specifies the IP address or host name from which the packet was
sent. Specify any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
•
source-wildcard
— (Optional for the first type) Specifies wildcard bits by
placing 1’s in bit positions to be ignored. Specify any to indicate IP address
0.0.0.0 and mask 255.255.255.255.
•
destination
— Specifies the IP address or host name to which the packet is
being sent. Specify any to indicate IP address 0.0.0.0 and mask
255.255.255.255.
•
destination-wildcard
— (Optional for the first type) Specifies wildcard bits
by placing 1’s in bit positions to be ignored. Specify any to indicate IP
address 0.0.0.0 and mask 255.255.255.255.
To Next Page
Loading...
