D-Link DES-1210-28/ME - Cable Diagnostic Port

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
92
Command: disable gratuitous_arp trap
Success!
DES-1210-28/ME:5#
show gratuitous_arp
Purpose Used to display the gratuitous ARP configuration.
Syntax
show gratuitous_arp
Description
The show gratuitous_arp command is used to display the
gratuitous ARP configuration.
Parameters None.
Restrictions None.
Example usage:
To display gratuitous ARP log and trap states:
DES-1210-28/ME:5# show gratuitous_arp
Command: show gratuitous_arp
Send on IPIF status up : Enabled
Send on Duplicate_IP_Detected : Enabled
Gratuitous ARP Learning : Enabled
IP Interface Name : System
Gratuitous ARP Trap : Enabled
Gratuitous ARP Log : Disabled
Gratuitous ARP Periodical Send Interval : 0
DES-1210-28/ME:5#
config gratuitous_arp send periodically interval
Purpose Used to configure the interval for periodical sending of gratuitous
ARP request packets.
Syntax
config gratuitous_arp send periodically interval <integer 0-
65535>
Description
The config gratuitous_arp send periodically interval command is
used to configure the interval for periodical sending of gratuitous
ARP request packets. By default, the interval is 0.
Parameters
<integer 0-65535> − Periodically send gratuitous ARP interval time
in seconds. 0 means it will not send gratuitous ARP periodically.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure gratuitous ARP intervals for the Switch: