D-Link DES-1210-28/ME - Clear Igmp_Snooping Data_Driven_Group; Config Igmp_Snooping Max_Response_Time; To Configure Max Response Time

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
197
Success !
DES-1210-28/ME:5#
clear igmp_snooping data_driven_group
Purpose To clear the IGMP snooping group learned by data drive.
Syntax
clear igmp_snooping data_driven_group [all | vlan_name
<vlan_name 20> | vlanid <integer 1-4094>] [all | MCGroupAddr
<ipaddr>]
Description
The config igmp_snooping data_driven_learning command is
used to delete the IGMP snooping group learned by data drive.
Note that this commands is currently only for layer 2 switches.
Parameters
all − Delete all data driven entries.
vlan_name <vlan_name 20> − The name of the VLAN for which
IGMP snooping is to be configured. Up to 20 characters can be
used.
vlanid <integer 1-4094> − Specify the vlan id of the IGMP snooping
data driven group on the Switch.
<ipaddr> - Specifies the IP address
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To clear the igmp snooping data driven group on the Switch:
DES-1210-28/ME:5# clear igmp_snooping data_driven_group all all
Command: clear igmp_snooping data_driven_group all all
Success !
DES-1210-28/ME:5#
config igmp_snooping max_response_time
Purpose To configure max response time.
Syntax
config igmp_snooping max_response_time <integer 10-25>
Description
The config igmp_snooping max_response_time command
configures the max response time for IGMP snooping on the Switch.
Parameters
<integer 10-25> − Specify the max response time for IGMP
snooping on the Switch.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the max response time for IGMP snooping:
DES-1210-28/ME:5# config igmp_snooping max_response_time 12
Command: config igmp_snooping max_response_time 12