D-Link DES-1210-28/ME - Show Syslog Host; Cable Diagnostic Port

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
104
To delete a previously configured syslog host:
DES-1210-28/ME:5# delete syslog host all
Command: delete syslog host all
Success!
DES-1210-28/ME:5#
show syslog host
Purpose To display the syslog hosts currently configured on the Switch.
Syntax
show syslog host {<index 1-4>}
Description
The show syslog host command displays the syslog hosts that are
currently configured on the Switch.
Parameters
<index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
Restrictions None.
Example usage:
To show Syslog host information:
DES-1210-28/ME:5# show syslog host
Command: show syslog host
Host ID Host IP Address Severity Facility UDP Port Status
--------- ----------------------- ----------- ------------ ------------- -----------
1 1.1.2.1 All Local0 514 Enabled
Total Entries : 1
DES-1210-28/ME:5#
cable diagnostic port
Purpose To determine if there are any errors on the copper cables and the
position where the errors may have occurred.
Syntax
cable diagnostic port [<portlist> | all]
Description
The cable diagnostic port command is used to determine if there
are any errors on the copper cables and the position where the
errors may have occurred. Cable length is detected as following
range: <50m, 50~80, 80~100, >100m. Deviation is +/-5 meters,
therefore "No Cable" may be displayed under "Test Result," when
the cable used is less than 5 m in length. The Fault Distance will
show “No Cable”, whether the fiber is connected to the port or not.
Parameters
<portlist> – A port or range of ports to be configured.
all − Specifies all ports on the Switch are to be configured.
Restrictions None.
Example usage: