D-Link DES-1210-28/ME - Config Dhcp_Server Screening Ports; Show Dhcp_Server Screening

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
43
config dhcp_server screening ports
Purpose To configure a DHCP server screening from the DHCP Relay server
list.
Syntax
config dhcp_server screening ports <portlist> state [enable |
disable]
Description
The config dhcp_server screening ports command configures the
ports of DHCP servers screening on the Switch.
Parameters
<portlist> − Specifies a port or a range of ports to be configured.
state [enable | disable] − Enable/Disable the DHCP server
screening for the specified ports.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To configure the DHCP server screening of port 1~5 on the Switch:
DES-1210-28/ME:5# config dhcp_server screening ports 1-5 state enable
Command: config dhcp_server screening ports 1-5 state enable
Success.
DES-1210-28/ME:5#
show dhcp_server screening
Purpose To display the DHCP server screening on the Switch .
Syntax
show dhcp_server screening
Description
The show dhcp_server screening command displays the DHCP
server screening on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display DHCP server screening settings:
DES-1210-28/ME:5# show dhcp_server screening
Command: show dhcp_server screening
DHCP server screening :
Port Admin state
---- -----------
1 disabled
2 disabled
3 disabled
4 disabled
5 disabled
6 disabled
7 disabled
8 disabled
9 disabled