D-Link DES-1210-28/ME - 802.1 X Commands

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
199
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To deny router ports:
DES-1210-28/ME:5# config router_ports_forbidden vlanid 2 add 10-12
Command: config router_ports_forbidden vlanid 2 add 10-12
Success !
DES-1210-28/ME:5#
config igmp access_authentication ports
Purpose To configure the IGMP access authentication on the Switch.
Syntax
config igmp access_authentication ports [<portlist> | all] state
[enable | disable]
Description
The config igmp access_authentication ports command
configures the IGMP access authentication on the Switch.
Parameters
<portlist> − A port or range of ports that will be configured as IGMP
access authentication ports.
all − Specify all ports to be configured as IGMP access
authentication ports.
state[enable | disable] − Specifies the state for the port to be
disabled or enabled.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure authentication port of IGMP:
DES-1210-28/ME:5# config igmp access_authentication ports all state
enable
Command: config igmp access_authentication ports all state enable
Success !
DES-1210-28/ME:5#
show igmp access_authentication ports
Purpose To display the IGMP access authentication configuration on the
Switch.
Syntax
show igmp access_authentication ports [<portlist> | all]
Description
The show igmp access_authentication command displays the
IGMP access authentication configuration on the Switch.
Parameters
all − Specifies all ports to be displayed.
<portlist> − A port or range of ports to be displayed on the Switch.
Restrictions None.
Example usage:
To display the IGMP access authentication: