DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
16
disable web
Purpose To disable the HTTP-based management software on the Switch.
Syntax
disable web
Description
The disable web command disables the Web-based management
software on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable HTTP-based management software on the Switch:
DES-1210-28/ME:5# disable web
Command: disable web
Success.
DES-1210-28/ME:5#
enable autoconfig
Purpose Used to activate the auto configuration function for the Switch. This
will load a previously saved configuration file for current use.
Syntax
enable autoconfig
Description When autoconfig is enabled on the Switch, the DHCP reply will
contain a configuration file and path name. It will then request the file
from the TFTP server specified in the reply. When autoconfig is
enabled, the ipif settings will automatically become DHCP client.
Parameters None.
Restrictions When autoconfig is enabled, the Switch becomes a DHCP client
automatically (same as: config ipif System dhcp). The DHCP server
must have the TFTP server IP address and configuration file name,
and be configured to deliver this information in the data field of the
DHCP reply packet. The TFTP server must be running and have the
requested configuration file in its base directory when the request is
received from the Switch. Consult the DHCP server and TFTP
server software instructions for information on loading a
configuration file.
If the Switch is unable to complete the auto configuration process
the previously saved local configuration file present in Switch
memory will be loaded.
Example usage:
To enable auto configuration on the Switch:
DES-1210-28/ME:5# enable autoconfig
Command: enable autoconfig
Success.
DES-1210-28/ME:5#
To Next Page
Loading...
