D-Link DES-1210-28/ME - Disable Snmp; Enable Snmp DHCP_ Screening Traps

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
70
Description
The enable snmp command enables SNMP support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command
Example usage:
To enable SNMP support on the Switch:
DES-1210-28/ME:5# enable snmp
Command: enable snmp
Success!
DES-1210-28/ME:5#
disable snmp
Purpose To disable SNMP support.
Syntax
disable snmp
Description
The disable snmp command enables SNMP support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command
Example usage:
To disable SNMP support on the Switch:
DES-1210-28/ME:5# disable snmp
Command: disable snmp
Success!
DES-1210-28/ME:5#
enable snmp DHCP_ screening traps
Purpose To enable SNMP DHCP screening traps.
Syntax
enable snmp DHCP_screening traps
Description
The enable snmp DHCP_screening traps command enables
SNMP DHCP screening traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command
Example usage:
To enable SNMP DHCP screening traps support on the Switch:
DES-1210-28/ME:5# enable snmp DHCP_screening traps
Command: enable snmp DHCP_screening traps
Success!