D-Link DES-1210-28/ME - Config Pvid; Config Gvrp Timer

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
162
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port, by VLAN ID.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To set the ingress checking status:
DES-1210-28/ME:5# config gvrp all ingress_checking enable
Command: config gvrp all ingress_checking enable
Success.
DES-1210-28/ME:5#
config pvid
Purpose To configure the pvid on the Switch.
Syntax
config pvid <int 1-4094> ports <portlist>
Description
The config pvid command configures the Group VLAN Registration
Protocol on the Switch.
Parameters <int 1-4094> − Specifies the PVID to be configured.
<portlist> − A port or range of ports which user want to configure
with.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the PVID on the Switch:
DES-1210-28/ME:5# config pvid 1 ports 2
Command: config pvid 1 ports 2
Success.
DES-1210-28/ME:5#
config gvrp timer
Purpose To configure GVRP on the Switch.
Syntax
config gvrp timer [join_timer <sec 10-100000> | leave_timer
<sec 10-100000> | leave-all_timer <sec 10-100000>]
Description
The config gvrp timer command configures the Group VLAN
Registration Protocol on the Switch. The user can configure ingress
checking and acceptable frame tagged only, the sending and
receiving of GVRP information, and the Port VLAN ID (PVID).
Parameters
join_timer <sec 10-100000> − Specifies the join time for the GVRP
on the Switch. The time range is from 10 to 100000 seconds.
leave_timer <sec 10-100000> − Specifies the leave time for the
GVRP on the Switch. The time range is from 10 to 100000 seconds.
leave-all_timer_<sec 10-100000> − Specifies the leave all time for
the GVRP on the Switch. The time range is from 10 to 100000
seconds.