D-Link DES-1210-28/ME - Show Filter Dhcp_Server

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
42
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To add an entry from the DHCP server/client filter list in the Switch’s database:
DES-1210-28/ME:5# config filter dhcp_server add permit server_ip
10.1.1.1 client_mac 00-00-00-00-00-01 ports all
Command: config filter dhcp_server add permit server_ip 10.1.1.1
client_mac 00-0
0-00-00-00-01 ports all
Success!
DES-1210-28/ME:5#
show filter dhcp_server
Purpose Used to display current DHCP server/client filter list created on the
switch.
Syntax
show filter dhcp_server
Description
The show filter dhcp_server command is used to display DHCP
server/client filter list created on the switch.
Parameters None.
Restrictions None.
Example usage:
To display the DHCP server filter list created on the switch:
DES-1210-28/ME:5# show filter dhcp_server
Command: show filter dhcp_server
IP Address MAC Address Ports
--------------- ----------------- ------------------------------
10.1.1.1 00-00-00-00-00-01 1-28
Total Entries: 1
Success!
DES-1210-28/ME:5#