D-Link DES-1210-28/ME - Limited Ip Multicast Address Commands; Create Mcast_Filter_Profile

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
205
31
3131
31
LIMITED IP MULTICAST ADDRESS COMMANDS
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
create
mcast_filter_profile
profile_id <integer 1-24> profile_name <string 32>
config
mcast_filter_profile
profile_id
<integer 1-24> [add | delete] <ip_addr>
config
mcast_filter_profile
profile_name
<string 32> [add | delete] <ip_addr>
delete
mcast_filter_profile
[profile_id<integer 1-24> | profile_name <string 20>]
show
mcast_filter_profile
{profile_id <integer 1-24> | profile_name <string 32>}
config
limited_multicast_addr
ports
<portlist> {[add | delete] [profile_id <integer 1-24> | profile_name <string 32>] |
access [permit | deny]}
show
limited_multicast_addr
ports <portlist>
config
max_mcast_group
<portlist> max_group <integer 1-256>
show
max_mcast_group
<portlist>
Each command is listed in detail, as follows:
create mcast_filter_profile
Purpose To create multicast filtering profile on the Switch.
Syntax
create mcast_filter_profile profile_id <integer 1-24>
profile_name <string 32>
Description
The create mcast_filter_profile command displays the multicast
filtering profiles settings.
Parameters
profile_id <integer 1-24> - Specify the profile id of multicast filter
profile on the Switch.
profile_name <string 32> - Specify the profile name of multicast filter
profile on the Switch.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To create multicast filtering profile on the Switch: