D-Link DES-1210-28/ME - Show Traffic Control; Config Traffic Trap

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
127
To configure traffic control and enable broadcast storm control system wide:
DES-1210-28/ME:5# config traffic control all multicast enable unicast disable br
oadcast enable threshold 65
Command: config traffic control all multicast enable unicast disable broadcast
enable threshold 65
Success.
DES-1210-28/ME:5#
show traffic control
Purpose To display current traffic control settings.
Syntax
show traffic control {<portlist>}
Description
The show traffic control command displays the current storm traffic
control configuration on the Switch.
Parameters
<portlist> - A port or range of ports whose settings are to be
displayed.
Restrictions None.
Example usage:
To display traffic control setting for ports 1-5:
DES-1210-28/ME:5# show traffic control 1-5
Command: show traffic control 1-5
Port Thres Broadcast Multicast Unicast
hold Storm Storm Storm
---- ------- --------- --------- --------
1 65 Enabled Enabled Disabled
2 65 Enabled Enabled Disabled
3 65 Enabled Enabled Disabled
4 65 Enabled Enabled Disabled
5 65 Enabled Enabled Disabled
Total Entries : 5
DES-1210-28/ME:5#
config traffic trap
Purpose To configure the traffic control trap on the Switch.
Syntax
config traffic trap [storm_cleared | storm_occured | both | none]
Description
The config traffic trap command configures the current storm traffic
trap configuration on the Switch.
Parameters
storm_cleared – A notification will be generated when a storm event