D-Link DES-1210-28/ME - Delete Snmp View; Show Snmp View

DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
56
Success!
DES-1210-28/ME:5#
delete snmp view
Purpose To remove an SNMP view entry previously created on the Switch.
Syntax
delete snmp view <view_name 32> <oid 32>
Description
The delete snmp view command removes an SNMP view
previously created on the Switch.
Parameters
<view_name 32> − A string of up to 32 alphanumeric characters that
identifies the SNMP view to be deleted.
<oid 32> − The object ID that identifies an object tree (MIB tree) that
is deleted from the Switch.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To delete a previously configured SNMP view from the Switch:
DES-1210-28/ME:5# delete snmp view dlink 1.3.6
Command: delete snmp view dlink 1.3.6
Success.
DES-1210-28/ME:5#
show snmp view
Purpose To display an SNMP view previously created on the Switch.
Syntax
show snmp view {<view_name 32>}
Description
The show snmp view command displays an SNMP view previously
created on the Switch.
Parameters
<view_name 32> − A string of up to 30 alphanumeric characters that
identifies the SNMP view to be displayed.
Restrictions None.
Example usage:
To display SNMP view configuration:
DES-1210-28/ME:5# show snmp view
Command: show snmp view
SNMP View Table Configuration
View Name Subtree OID OID Mask View Type
------------ ---------------------- ---------------------- ---------
dlink 1.2.3.4 1.1.1.1 Excluded
ReadWrite 1 1 Included